BMR XTREME ANTI-ROLL BAR KIT - REAR - SOLID 1.375" - 3" AXLES - 1964-1972 A-BODY - RED - XSB006R
BMR XTREME ANTI-ROLL BAR KIT - REAR - SOLID 1.375" - 3" AXLES - 1964-1972 A-BODY - RED - XSB006RHard launches from high horsepower cars at the drag strip require more that just a normal street-style sway bar. BMR Suspension’s Xtreme Anti Roll Bar for 1964-1972 GM A-Body allows you to launch harder without excessive body roll limiting traction, with little sacrifice to your A-Body’s street manners. Manufactured from 1.375-inch solid bar stock, BMR’s Xtreme Anti Roll Bar (XSB006) is designed to eliminate body roll and transfer as much power as possible to the rear wheels. The XSB006 attaches to your A-Body with polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 95-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing under high compression loads. The fabricated laser cut, steel sway bar mounts are reinforced to add strength and minimize deflection. BMR Suspension designed the XSB006 sway bar for street performance and drag race applications. The large adjustable sway bar has two positions, giving you the versatility to drive to and from the track with the same sway bar. The XSB006 gives you a massive increase in rate over the stock bar (depending on year and model). These rate increases and adjustability allow you to almost eliminate body roll so you can leave the starting line harder with maximum traction. The hollow design gives you loads of strength without adding a lot of weight. This allows for more body roll control, which equals more traction and consistent launches. When performance is a must, rely on BMR Suspension! BMR Suspension’s XSB006 anti roll bar is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!
|Part Type||Anti Roll Bar|