BMR SWAY BAR KIT WITH BUSHINGS - FRONT (SB008H) AND REAR (SB009H) - 1964-1972 A-BODY - BLACK - SB028H
Only 1 left
BMR SWAY BAR KIT WITH BUSHINGS - FRONT (SB008H) AND REAR (SB009H) - 1964-1972 A-BODY - BLACK - SB028HThe two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspension’s SB028 front and rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, and coil spring rate. Manufactured from heavy-duty, solid 32mm bar stock (front) and solid 1-inch bar stock 9rear), the SB028 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bars are CNC-formed for exact manufacturing tolerances and repeatable high quality. The front sway bar mounts to the car using polyurethane bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keeps grease in the bushing. The steel sway bar mounting brackets are reinforced to minimize deflection. The rear sway bar mounts to the rear lower control arm in the factory location. BMR Suspension designed the SB028 sway bar kit for street performance, autocross, and road race applications. The large sway bars’ increase in rate gives you the ability to drive to and from the road course or autocross and still out handle the competition with the same sway bars. The SB028 front and rear sway bar kit gives you a 400% (front) and 200% (rear) increase in sway bar rate. These rate increases allows you to greatly reduce the body roll of your A-body so you can drive harder through corners. The SB028 attaches to your A-body with 88-durometer polyurethane bushings (front), reducing the deflection from the stock rubber bushings. This allows for more sway bar control, and more control equals better handling. When performance is a must, rely on BMR Suspension! BMR Suspension’s SB028 sway bars are available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 3-4 hours. Proudly made in the U.S.A.!
|Part Type||Sway Bar|