BMR SWAY BAR KIT - FRONT - HOLLOW 32MM - NON-ADJUSTABLE - 2016-2017 CAMARO - RED - SB050R
Only 1 left
BMR SWAY BAR KIT - FRONT - HOLLOW 32MM - NON-ADJUSTABLE - 2016-2017 CAMARO - RED - SB050RThe two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspension’s SB050 front sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-duty 1.25-inch DOM steel tubing, the SB050 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. Thrust washers are welded to the front bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers The SB050 attaches to your Sixth Gen Camaro with polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing. BMR Suspension designed the SB050 sway bar kit for street performance, autocross, and road race applications. The large sway bars’ single position give you the ability to drive to and from the road course or autocross and still out handle the competition with the same sway bars. The SB049 front sway bar gives you a 62% increase in sway bar rate over the stock bar. This rate increase allow you to drive harder through corners with minimal body roll. The hollow design allows for loads of strength in the lightest package possible. This means increased performance with no sacrifices. The SB050 attaches to your Camaro with 88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. This allows for more sway bar control, which equals better handling. When performance is a must, rely on BMR Suspension! BMR Suspension’s SB050 sway bar kit is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!
|Part Type||Sway Bar|